Different Things You Need To Consider While Installing Garage Door Cables
Posted By Houston Decorator on November 23, 2010
Garage door cables are not hard to install provided you possess basic knowledge of performing different tasks related to cables and wires. And considering the fact that these doors are widely used throughout the day, while opening and closing for different purposes, chances are always that the cables might get aligned wrongly or broken at different sections. In fact, these problems are commonly seen in cables and as such they have to be replaced sooner than later.
If you are considering installing these door cables yourself, you may well need different materials or tools for your purpose. Few of them include: door cables, 2 grips, gloves, screwdriver, 3 inch wrench, cable stripper, and ladder.
1st Step: – Preparation
As a first step in installing the garage door cables you need to collect all the above materials and tools. It is absolutely necessary to have protective gears near by before attempting to install the cables yourself.
2nd Step: – Wrapping the cables
After gathering all the materials and tools that you will need for installation purpose, you should then wrap the guide of cables over the pulley. The laying of cable over pulley has to be done in such a way that they have to extend towards the arm of the cable and then get it connected against the garage track or ceiling. Before you route the cables this way, you need to make sure that the door is properly closed. In a way, this will ensure that they are properly screwed and tightened.
3rd step: – Attaching the cables
You will then need to attach the door cables in the slots that are provided at the bottom section of your door. While doing this, ensure that the cable ends are properly inserted into the slots so that they can rest against the garage door track properly. If the resting of cables are not done properly, there are chances that the installation will collapse. After the cables are in their place, their ends need to be attached to the overhead setting. For this, you will first need to loosen the screws and then insert the cables. Upon placing the cables, screws can be tightened.
4th step: – Troubleshooting the installation
After installing the cables you will need to check if the garage door opens properly or not. If there are problems, you will need to check if the cables are resting properly on tracks as mentioned earlier. You then have to check the applied tension and see if it high. If the problem persists, you may have to replace your shorter cables and get longer ones in their place.
Dan Pevney has been providing helpful information regarding Garage Door Repair Orlando for many years. His expertise is the result of years of hands on experience in the garage door business. If you are having trouble with your door and would like some help he recommends giving Garage Door Orlando a call.
Comments
Leave a Reply